I have the vehicle listed above... I have completely replaced all parts in the braking system except the abs pump which still functions
Changed:
Power booster
Master cylinder
Proportoning valve
Rubber hoses
Calipers
Wheel cylinders
New rotors
Best non ceramic pads $ can buy on from and shoes on back
I can only get a semi hard brake pedal but I have pretty decent stopping(much better than before I changed the power booster)
Any thoughts on getting a more firm pedal??
Response:
On SOME Jeep Trucks on the rear axle where the brake lines connect is a "Limiter" that functions to allow more fluid to the rear brakes as more payload is gained. On others there is an electrical switch simular to a leveling device that controls the computer and ABS distribution. every wheel has a speed sensor that control each wheel by pressure and signal to the computer. If you have a Bendix System the Accumulator is part of the Pump Assy.
No comments:
Post a Comment