2007 Toyota Prius TSB #PG0003-06
If the battery terminal has been disconnected, the “one-touch open and close” and
“jam protection” functions of the driver’s door power window will be inoperative due to
loss of the driver’s door power window position memory stored in the microcomputer.
Initialization of the driver’s door power window will be necessary after the battery
is reconnected.
NOTE:
Any time the battery terminal has been disconnected, the power window MUST
be re-initialized.
Initialization
Procedure
1. Turn the ignition switch to the “ON”
position. At this time, the power
window switch for the driver’s door
window should be blinking.
2. Push down and hold the driver’s door
power window switch to completely
open the window.
3. Pull and hold up the driver’s door
power window switch until the window
closes. Continue holding the switch
for approximately one second until the
switch changes from blinking to a
constant illumination.
4. Check for proper operation of the
“one-touch open and close” by fully
pushing the switch “DOWN” once and
fully pulling the switch “UP” once.
NOTE:
Jam protection function becomes
effective through the above
initialization procedure.
No comments:
Post a Comment